Central hydraulic width adjustment Xview ; simultaneously or separately adjustable via parallelogram
Two double acting hydraulic masts 500mm or 800mm; simultaneous or separate height adjustment
Comfort Controller with joystick operation
PROcut cutter boards made of anodized aluminum profile with easy to clean, high grade anodized
surface
Closed drive unit and encapsulated bearings prevent penetration by water and contamination of the
bearings
Optimally dimensioned, maintenance free V ribbed belt drive
The V ribbed belts do not require retightening and allow greater transmittable output (higher
torque)
Turbo knife 2.0 for high cutting performance and increased cutting quality (rejecting the wire)
Stainless steel deflector plates on the horizontal and vertical cutter boards
Diverse adjustment options
Hydraulic width adjustment for cutting widths from 1.10m 2.65m (inner cutter boards)
Hydraulic lateral tilt of vertical cutter boards +/ 15 each side (Tilt function via hydraulic lift, simultaneously or separately adjustable)
Manual adjustment of the horizontal cutting angle: 90°
Manual adjustment of the horizontal cutting height : 40cm
Pivoting of the horizontal cutter boards to the rear for transport
Gas spring Impact protection on horizontal and vertical cutter boards with automatic return to the initial position
Storage stand
| Vertical cutter boards (1 set, consisting of 2 vertical PROcut cutter boards) |
| PROcut cutter boards 1.35m (4 knives) |
| PROcut cutter boards 1.55m (5 knives) |
| PROcut cutter boards 1.65m (5 knives) |
| PROcut cutter boards 1.85m (6 knives) |
| PROcut cutter boards 1.95m (6 knives) |
| Horizontal cutter boards (1 set, consisting of 2 horizontal PROcut cutter) |
| Horizontal cutter boards 0.85m (3 knives) |
| Horizontal cutter boards 1.10m (4 knives) |
Hydraulic adjustment of the horizontal cutting angle 0° - 90°
Hydraulic adjustment of the horizontal cutting height : 40cm
Lower cutter board (1 knife ), continuously adjustable up to 45° manual ) with separate hydraulic motor
Lower cutter board (2 knives ), continuously adjustable up to 45° manual ) with separate hydraulic motor
Shoot lifters for mounting to vertical cutter boards or for mounting to lower cutter boards